AudioPervert Home
Contact AudioPervert
   Home : Pro One : Compressor : SidStation Rack : MicMix Spring Reverb Manual : Linn K9 stylus   
 

MicMix STUDIO B Master-Room spring reverb
 


Test
Point

Nominal
Reading

Limits
Min     Max

Notes

13

+ 11. 2 DC

10. 8      1 1. 5

 

14

See notes.

0.9      1. 15

Varies from 0 to 4. 5 volts DC above TP# 5 as REVERB control is varied from minimum to maximum (DECAY control at mid-point) .

15

See notes.

 

DC volts above TP #5 reading

16

See notes.

 

Varies from 0. 25 to 3. 8 volts DC above TP#5 as REVERB control is varied from minimum to maximum (DECAY control at mid-point).

17

See notes.

6. 5      7.0

DC volts above TP #5 reading

Two internal potentiometers (R32 and R49) are provided. Adjustment of these controls requires a 50 volt well-filtered variable DC power supply having a 0-100 milliampere meter on the output.

DISCONNECT THE AC POWER CORD

Set the power supply for 48 ± 1 volt and the meter for 100 ma full scale. Attach the power supply to the DC input banana jacks on the rear of the STUDIO B chassis (Red pos. , Blk neg. l. The steady current with no audio input should be 48 to 50 ma.

Remove Q21 from its socket. The power supply current should drop 8 ma. If it does not, adjust R32 such that removal and reinsertior~ of Q21 causes a current draw change of 8 ma.

CAUTION: Orient the tab on Q21 in accordance with the socket when re-inserting. Turn ,power off when re-inserting IC's.

Remove Q41 from its socket. The power supply current should drop
by 12 ma. If it does not, adjust R43 such that removal and re-insertion of Q41 causes a current draw change of 12 ma.

CAUTION: Orient the tab on Q41 in accordance with the socket when re-inserting. Turn power off when re-inserting IC's.

 
  <previous : home : next>
AudioPervertElectronics